Abstract: The article presents results of comparative tests performed to verify the conformity of geometric deviation measurements of a crankshaft carried out at a test bed equipped with a system of elastic support with measurements adopted as reference values. A number of simulation tests were carried out with varied shaft support conditions using the proposed measuring system. The selection criteria were established for support parameters. Meeting these criteria guarantees that shaft elastic deflections and strains are eliminated. Consequently, such strains will not affect the estimation of geometrical deviations of the measured object. The comparative evaluation measurement of roundness profiles and values of roundness deviations of main crankshaft bearing journals of a marine medium speed engine was performed using a correlation calculus. The results have revealed high conformity of both determined roundness deviation values and measured profiles compared to the reference ones.
B I B L I O G R A F I A[1] Nozdrzykowski, K. (2011). Crankshaft support requirements for measurement of its geometry errors. Mechanik, 05/06, 466–468.
[2] Nozdrzykowski, K. (2011). A system for measurements of geometrical deviation of main-pin crankshaft assembly. Pomiary Automatyka Kontrola, 57(12), 1592–1594.
[3] Adamczak, S., Janusiewicz, A., Makieła, W., Stępień, K. (2011). Statistical validation of the method for measuring radius variations of components on the machine tool. Metrology and Measurement Systems, Vol. XVIIII, 1, 35–46.
[4] Janecki, D., Adamczak, S., Stępień, K. (2008). An analysis of the applicability of the cross-correlation function to the comparision of cylindrical profiles. Pomiary Automatyka Kontrola, 54(5), 237–243.
[5] Janecki, D., Adamczak, S., Stępień, K. (2004). Analysis of the accuracy of reference cylindricity measurements using the normalized cross correlation function. Science report, Project PL-127, CEEPUS, Kielce University of Technology, 57–66.
[6] Adamczak, S., Janecki, D., Stępień, K. (2005). The Comparison of cylindricity profiles using normalized cross-correlation function. In Proc. of 5th International Conference Measurement 2005, Smolenice (SK), 363–366.
[7] Nowaczyk, C. (1985). Fundamentals of statistical methods. PWN, Warszawa-Poznań.
[8] Adamczak, S. (2008). Measurement of surface texture. Form profiles, waviness and roughness. W"T Warszawa.
[9] Nozdrzykowski, K. (2005). Comparative assessment of crankshaft strain measurement methods. In Proc. of 5th International Conference Measurement 2005, Smolenice (SK), 425–428. 
Pełny tekst 
DOI 
Web of Science