Notice: Undefined index: linkPowrot in C:\wwwroot\wwwroot\publikacje\publikacje.php on line 1286
Publikacje
Pomoc (F2)
Dane niepełne - brak ISSN !

[141830] Artykuł:

Comparative studies of stations for transferring mass units

Czasopismo: Measurement: Sensors  
Opublikowano: Maj 2025
 
  Autorzy / Redaktorzy / Twórcy
Imię i nazwisko Wydział Katedra Do oświadczenia
nr 3
Grupa
przynależności
Dyscyplina
naukowa
Procent
udziału
Liczba
punktów
do oceny pracownika
Liczba
punktów wg
kryteriów ewaluacji
Monika Sej WMiBMKatedra Metrologii i Niekonwencjonalnych Metod WytwarzaniaTakdoktorant szkoły doktorskiejInżynieria mechaniczna80.00.00  
Krzysztof Stępień orcid logo WMiBMKatedra Metrologii i Niekonwencjonalnych Metod WytwarzaniaNiezaliczony do "N"Inżynieria mechaniczna20.00.00  

Grupa MNiSW:  Publikacja w czasopismach wymienionych w wykazie ministra MNiSzW (część A)
Punkty MNiSW: 0


Pełny tekstPełny tekst     DOI LogoDOI    
Keywords:

Kilogram  Redefinition  Vacuum mass comparator  Vibrations  Mass transfer 



Abstract:

The global redefinition of the kilogram has increased the importance of precision in the transfer of mass units, posing challenges for National Metrology Institutes, including the Central Office of Measures (GUM) in Poland. The article addresses the issue of mass measurements using high-precision comparators. Such measurements are conducted at the Central Office of Measures (GUM) in Poland. To enhance the capabilities of the Mass Laboratory at GUM, a new AVK1000 comparator was purchased. However, initial measurements with the new comparator indicated significant discrepancies in the obtained results. Therefore, a comparative study of the new comparator and the previously used comparator was conducted.
A comparative analysis of the new AVK1000 mass comparator with the previous AT1006 comparator revealed that the new station did not meet the expected repeatability parameters. The AVK1000 showed significantly greater variability, indicating the need for further improvements. The modernisation project included the delivery and installation of the measurement module, achieving high vacuum, and equipping it for measurements in an inert gas atmosphere. Additionally, the analysis of the impact of vibrations on measurement repeatability highlighted the need for further research on their influence on accuracy.