Notice: Undefined index: linkPowrot in C:\wwwroot\wwwroot\publikacje\publikacje.php on line 1275
Publikacje
Pomoc (F2)
[13964] Artykuł:

The superficial layer of parts machined by brush electro-discharge mechanical machining (BEDMM)

Czasopismo: Proceedings of the Institution of Mechanical Engineers Part B-Journal of Engineering Manufacture   Tom: 218, Zeszyt: 1, Strony: 9-15
ISSN:  0954-4054
Wydawca:  PROFESSIONAL ENGINEERING PUBLISHING LTD, NORTHGATE AVENUE, BURY ST EDMUNDS IP32 6BW, SUFFOLK, ENGLAND
Opublikowano: Styczeń 2004
 
  Autorzy / Redaktorzy / Twórcy
Imię i nazwisko Wydział Katedra Procent
udziału
Liczba
punktów
Bogdan Nowicki33.00  
Robert Pierzynowski33.00  
Sławomir Spadło orcid logoWMiBMKatedra Technik Komputerowych i Uzbrojenia**3315.00  

Grupa MNiSW:  Publikacja w czasopismach wymienionych w wykazie ministra MNiSzW (część A)
Punkty MNiSW: 15
Klasyfikacja Web of Science: Article; Proceedings Paper


Pełny tekstPełny tekst     DOI LogoDOI     Web of Science Logo Web of Science    
Keywords:

electro-discharge machining  superficial layer  residual stress 



Abstract:

The paper presents a brief study of brush electro-discharge mechanical machining (BEDMM) with an elastic, discrete electrode. This method is useful for the smoothing of free-form surfaces using a general-use electrode. It can be realized as a combination of mechanical and erosion machining or it can be effected with the same tool as an additional operation of mechanical machining that would result with additional smoothing and introduction of the compression stress into the surface layer. The surface layer created after BEDMM is featured with a considerable share of the cathode material and the obtained roughness Ra is approximately 1 μm.